- Easy measurement of thickness, outer diameter, inner diameter and depth.
- Handy size with excellent functions.
- Minimum reading : 0.1mm.
EG-1for measurement of inner diameter, outer diameter and thickness.
EG-2for measurement of inner diameter, outer diameter and thickness and depth.
Snap Calipers: EG-1, EG-2
Model |
EG-1 |
Graduation |
0.1mm |
Range ; Measurement of thickness |
0 ~ 20mm |
Range ; Measurement of inner diameter |
3 ~ 23mm |
|
Model |
EG-2 |
Graduation |
0.1mm |
Range ; Measurement of thickness |
0 ~ 20mm |
Range ; Measurement of inner diameter |
3 ~ 23mm |
Range ; Measurement of depth |
0 ~ 20mm |
|
|
|
|
|
How to use Snap Caliper ( EG-1, EG-2 )
To measure thickness and diameter of balls :
- First, press down a knob to check whether a pointer shows 0.
- As shown in the drawing II , put an object for measurement between a contact point
and anvil, and read a position of pointer on a dial plate. A division of scale is 0.1 mm,
so read the values on the dial 1, 2, 3… as 1, 2, 3 mm… ( After one rotation, it shows 11,
12, 13 mm… )
- One rotation of a pointer shows 10 mm. Check whether it is first or second rotation by
reading a spindle scale indication.
( Example ):A pointer shows 6 at your measurement:
1st rotation –> 6 mm, 2nd rotation –> 16mm
|
|
To measure groove width and inner diameter :
- Press down a knob and have a contact point and anvil contacted fast, then rotate an
outer frame of gauge so that a division of 3 on a dial plate meets a position of pointer.
- Pressing down a knob by your fingers, insert the tips of contact point and anvil into the
inside of an object for measurement, and slowly release a knob, as shown in the
drawing III
( Notice ) :Measure an object at right angles to a groove. If you measure it diagonally,
a value larger than the actual one will be indicated.
|
|
To measure depth and step depth -( EG-2 only is available. )
- Rotate an outer frame of gauge so that a pointer meets 0 on a dial plate, by putting
a flat plate on the reference level of gauge. ( If there is no adequate plate, put your
gauge upside down, and press the reference level of gauge on a flat table ).
- Press your gauge down to the measuring part of an object for measurement, as
shown in the drawing IV
|
|
Major Specifications
- A division of scale 0.1mm
- Measuring Range :
for measurement of thickness 0 ~ 20mm
for measurement of inner diameter 3 ~ 23mm
for measurement of depth 0 ~ 20mm
- Weight :
EG-1 ; 97g
EG-2 ; 100g
Remarks
After your finishing measurements of internal diameter and step depth, adjust a pointer so as to meet 0 on a dial plate for thickness measurement.