It measure a depth from top bottom of bottomed holes, a depth of narrow grooves, a value of step height of stepped surfaces and a depth of types engraved in matrices. The dial gauge furnished offers a correct measured value since it can measure an object under measurement with a given measuring force.
Dial Depth Gauge (T series)
(20mm intervals). For T-1 type, replace the contact point in accordance with the measuring range.
|
|||||||||||||
and 80mm sizes For T-1W type, recombine the extension rods, in accordance with the measuring range. Two center-pointer type.
|
|||||||||||||
|
|||||||||||||
|
|||||||||||||
|
|||||||||||||
|
|||||||||||||
a right angle with the contact point, which facilitate easy reading from the upside.
|
|||||||||||||
|
|||||||||||||
Base Outer dia. Ø25mm Needle Contact Point dia. Ø2.0mm |
Base Outer dia. Ø25mm Needle Contact Point dia. Ø1.0mm |
Specifications
Model | Range (mm) |
Accuracy (µm) |
Dial Gauge | Base | |||||
Gauge installed |
Graduation (mm) |
Range (mm) |
Measuring force less than (N) |
Length (mm) | Width (mm) | ||||
T-1 | 0 – 160 | ±20 | 207F-T | 0.01 | 20 | 2.0 | 120 | 14 | |
T-1W | 0 – 220 | ±20 | 207WF-T | 0.01 | 20 | 2.0 | 100 | 11 | |
T-2 | 0 – 10 | ±15 | 107F-T | 0.01 | 10 | 1.4 | 60 | 14 | |
T-2W | 0 – 20 | ±20 | 207WF-T | 0.01 | 20 | 2.0 | 75 | 11 | |
T-2B | 0 – 5 | ±20 | 196B-T | 0.01 | 5 | 1.4 | 75 | 11 | |
T-2C | 0 – 10 | ±15 | 107F-T | 0.01 | 10 | 1.4 | 75 | 11 | |
T-3 | 0 – 10 | ±15 | 107F-T | 0.01 | 10 | 1.4 | 60 | Shown in figure | |
T-4 | 0 – 1 | ±5 | 5F | 0.001 | 1 | 1.5 | 40 | 10 | |
T-6A | 0 – 10 | ±15 | 107F-T | 0.01 | 10 | 1.4 | Ø25 | ||
T-6B | 0 – 10 | ±15 | 107F-T | 0.01 | 10 | 1.4 | Ø25 |
Dimensions
T-1
|
T-1W |
T-2 |
T-2W |
T-3 |
T-4 |
T-2B |
T-2C |
T-6A
T-6B