“PEACOCK” Caliper Gauges are quite useful for such measurements of O.D. or I.D. thickness and diameter which appear so difficult to measure.
Outside measuring (LA) type
|
Inside measuring (LB) type
|
Measuring thickness at the back
end of a projecting workpiece
LA-1 – LA-4
LA-13
LA-20 – LA-23
|
Measuring thickness at the back
end of a projecting workpiece
Dial upward type
LA-5
LA-5S
|
Measuring thickness of a cup,
hat or helmet
LA type
|
Measuring thickness or OD in a
narrow, confined place
LA type
|
Measuring center OD of a boss
LA-11
|
Floating type: lower contact
point has a flat 10mm diameter
LA-10 |
Measuring thickness by hurdling
a projecting area
LA type
|
Measuring thickness by hurdling
a projecting area
LA-8
|
Measuring thickness of a large
workpiece or part.
(A): workpiece sizes up to
500mm are accessible (LA-24).
|
Measuring thickness or OD in a
narrow, confined place
LA-9
LA-11
|
Measuring ID or groove width
LB-1 – LB-6
|
Measuring ID of a very shallow
hole
(A): approximately 2mm lip is
sufficient (LB-7V)
|
Measuring ID or an O-ring
groove
LB-1 – LB-6
|
Measuring ID by straddling the
center boss
LB-7
LB-14
|
|
Dial Calipers LA series (Outside measuring of ODs and thicknesses)
Dial Calipers LB series (Inside measuring of ID and groove widths)